User guide

Regulatory information

Federal Communications Commission Notice (FCC – United States)

FCC ID: PKRISGFX31001

Electronic devices, including computers and wireless modems, generate RF energy incidental to their intended function and are therefore subject to FCC rules and regulations.

This equipment has been tested to, and found to be within, the acceptable limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference when the equipment is operated in a residential environment.

This equipment generates radio frequency energy and is designed for use in accordance with the manufacturer’s user manual. However, there is no guarantee that interference will not occur in any particular installation. If this equipment causes harmful interference to radio or television reception, which can be determined by turning the equipment off and on, you are encouraged to try to correct the interference by one or more of the following measures.

  • Reorient or relocate the receiving antenna.
  • Increase the separation between the equipment and the receiver.
  • Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
  • Consult the dealer or an experienced radio/television technician for help.

This device complies with Part 15 of the Federal Communications Commission (FCC) Rules. Operation is subject to the following two conditions.

  • This device may not cause harmful interference.
  • This device must accept any interference received, including interference that may cause undesired operation.

WARNING: DO NOT ATTEMPT TO SERVICE THE WIRELESS COMMUNICATION DEVICE YOURSELF. SUCH ACTION MAY VOID THE WARRANTY. THIS DEVICE IS FACTORY TUNED. NO CUSTOMER CALIBRATION OR TUNING IS REQUIRED. CONTACT INSEEGO CORP TECHNICAL SUPPORT FOR INFORMATION ABOUT SERVICING YOUR WIRELESS COMMUNICATION DEVICE.

FCC CAUTION: Any changes or modification not expressly approved by the party responsible for compliance could void the user's authority to operate this equipment.

MODIFICATIONS: The FCC requires that you be notified that any changes or modifications made to this device that are not expressly approved by Inseego Corp. may void your authority to operate the equipment.

NOTE: The Radio Frequency (RF) emitter installed in your modem must not be located or operated in conjunction with any other antenna or transmitter, unless specifically authorized by INSEEGO CORP.

FCC RF EXPOSURE GUIDANCE STATEMENT: This device complies with FCC Radiation Exposure Limits set forth for Uncontrolled Environment. To ensure compliance with the FCC Radio Frequency Exposure Guidelines, this device must be installed to provide at least 20cm separation from the human body at all times.

Cellular external antenna considerations:

  1. External Antenna(s): Not Included
  2. To comply with RF Exposure Requirements, the Maximum Cellular Antenna Gain Must Not Exceed:
WWAN bandAntenna gain (dBi)
4G-LTE: B48 5G-FR1: n48, n77
≤ 1.5
4G-LTE: B2 5G-FR1: n2, n25
≤ 1.6
4G-LTE: B66 5G-FR1: n66
≤ 1.8
4G-LTE: B4
≤ 1.9
4G-LTE: B41 5G-FR1: n38, n41
≤ 2.8
In this article