Featured case study
Solutions
Products
Resources
Installation guide
Step four: orient the device
- Run the PoE cable to the desired location of the PoE injector and insert the cable into the Data & Power Out port. Plug the PoE injector into an earthed AC outlet. Consider using a surge protector when warranted.
NOTE: The PoE injector status LED does not indicate data transmission. The LED is red when the FW3000 is connected. The LED is green when the FW3000 is NOT connected and there is no load.
- Take a ratcheting socket wrench and device/smartphone with the Inseego Mobile app to the FW3000 location.
- Use the Inseego Mobile app and the positioning bolts on the pole mount bracket to fine tune the angle of the FW3000 for the best signal.
- Tighten the positioning bolts to 15.0 Nm (11 ft/lb).